tourqe spec. for ST 20v head

javiakakinghoopty
Club4AG Regular
Posts: 14
Joined: Sat Aug 03, 2013 6:29 pm

tourqe spec. for ST 20v head

Postby javiakakinghoopty » Mon Aug 05, 2013 3:49 am

Just replacing head gasket

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.


jdm86gtz
Club4AG Expert
Posts: 306
Joined: Fri Jan 11, 2013 10:13 pm
Location: Ireland

Re: tourqe spec. for ST 20v head

Postby jdm86gtz » Mon Aug 05, 2013 6:31 am

Same as a 16v head: 29Nm, turn 90 degrees, turn 90 degrees.
Tighten every bolt in each stage before moving to the next stage, starting in the middle of the head and working out in an X pattern.

yoshimitsuspeed
Club4AG MASTER
Posts: 2084
Joined: Sun Jan 13, 2013 1:18 pm
Contact:

Re: tourqe spec. for ST 20v head

Postby yoshimitsuspeed » Mon Aug 05, 2013 7:51 am

It should be noted that method only applies to a setup with stock headgasket and stock head bolts. If either of those change so must the tightening method.

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.



Return to “TECH: 4A-GE ENGINE”

Who is online

Users browsing this forum: No registered users and 2 guests