so i got started on one of the 2 free doors i recently got(big thanks to the guy who helped me out after the body panel fiasco i encountered), over the weekend. passengers side. some rust underneath near the drain holes, removed all seam sealer down there too.
![Image](http://imageshack.us/a/img7/9923/dsc02111dl.jpg)
looks like they were sitting outside for some time.
![Image](http://imageshack.us/a/img822/7417/dsc02112t.jpg)
wire wheeled the rust
![Image](http://imageshack.us/a/img507/6425/dsc02115f.jpg)
this corner was the worst, since it appears the door was dragged a good distance, so theres a flat there and the layers are seperated. i need to fix that up.
![Image](http://imageshack.us/a/img713/8623/dsc02114r.jpg)
pulled the side moulding off to see that it wad been resprayed at one time, and they masked off the moulding...crapola, what am i in for?!
![Image](http://imageshack.us/a/img22/9683/dsc02113zn.jpg)
not too bad, 2 seperate dents, but from the inside they look minor. sanded the outside completly, just need to remove the bondo and lay down some plastic body filler there, por-15 the rust inside and out, then scuff the inside areas for paint.
![Image](http://imageshack.us/a/img138/9783/dsc02116z.jpg)
once i get the doors done, ill stick them on the car and weld up the fender repairs. those pieces are all done, just need to weld them in.