20v GTS partout
20v GTS partout
Hey all looking to clear out some space in my garage for some new tools, had a GTS coupe involved in a front end collision, putting up most of what I dont need. Shoot me offers on anything, just trying to make space.
I have pretty nuch 2 interiors, and a chassis harness unmolested, plus heater/ac system with control panel. Have a spare fuel tank, a set of fuel and brake lines for the chassis, and just about a full car in my garage, Ill get pictures when I get around to digging them out.
20v motor, have tranny and driveshaft to go with it. Setup for turbo, manifold is ugly. Told it has low comp pistons, custom intake box. Not sure on miles but ran strong.Spec clutch I think (or fidanza, no stamping but how many yellow clutches are there?) Flywheel and clutch have alot of meat, no grooving and clutch was tight.
And the damage from the wrekc, frame hit the crank pulley and broke the hub so it needs a crank pulley and a water pump, motor turns over by hand just fine.
Pair of silver doors. No dents on them, just the rubber from moulding being pulled. Manual crank, interior panels are decent, driver side armrest had been patched with epoxy it looks like.
Factory LSD rearend off my '87. Never pulled axles so not sure if Kouki or Zenki. No noises or whines, LSD locks up no problem
Front sway bar/ Rear panhard. Have 2 rear panhards and bushings for both
Custom seat brackets, made for sparco side mounts. Mounted up in 2 cars, no fitment issues. Pretty low sitting.
Pair of fenders off my '87. Have been rolled and stretched pretty far, need a little bondo work to comnpletely smooth out, or just trim as desired.
Ill try to find pictures with them installed and wheels on
Pretty clean dash, just one crack on the drivers side
Zenki coupe tails, no cracks/chips. All lkights work, but no rubber gaskets
Elektromotive ECM. Not sure on model or much any info, but the local tuner is familiar with them, said once dialed in they are killer ECMs. Tune on it is on the rich side, could probably dial up boost and compensate just a bit
Greddy Boost controller with electronic vacuum block control, has all plugs and block.
Greddy Turbo Timer and Halmeter SF air/ fuel meter
Stock Brake booster, master cylinder, new clutch master, noname fuel pressure regulator and catch can
Stock pillowball mounts with upper spring cup
All this is in the midwest, my zip is 62040. You can call/text me at 618-709-2773 or reach me on here I usually check daily or so.
Shoot me offers, shipping is on the buyer, obviously bigger parts are preferred pick up.
Ill be updating this as I get more stuff off my shelves.
I have pretty nuch 2 interiors, and a chassis harness unmolested, plus heater/ac system with control panel. Have a spare fuel tank, a set of fuel and brake lines for the chassis, and just about a full car in my garage, Ill get pictures when I get around to digging them out.
20v motor, have tranny and driveshaft to go with it. Setup for turbo, manifold is ugly. Told it has low comp pistons, custom intake box. Not sure on miles but ran strong.Spec clutch I think (or fidanza, no stamping but how many yellow clutches are there?) Flywheel and clutch have alot of meat, no grooving and clutch was tight.
And the damage from the wrekc, frame hit the crank pulley and broke the hub so it needs a crank pulley and a water pump, motor turns over by hand just fine.
Pair of silver doors. No dents on them, just the rubber from moulding being pulled. Manual crank, interior panels are decent, driver side armrest had been patched with epoxy it looks like.
Factory LSD rearend off my '87. Never pulled axles so not sure if Kouki or Zenki. No noises or whines, LSD locks up no problem
Front sway bar/ Rear panhard. Have 2 rear panhards and bushings for both
Custom seat brackets, made for sparco side mounts. Mounted up in 2 cars, no fitment issues. Pretty low sitting.
Pair of fenders off my '87. Have been rolled and stretched pretty far, need a little bondo work to comnpletely smooth out, or just trim as desired.
Ill try to find pictures with them installed and wheels on
Pretty clean dash, just one crack on the drivers side
Zenki coupe tails, no cracks/chips. All lkights work, but no rubber gaskets
Elektromotive ECM. Not sure on model or much any info, but the local tuner is familiar with them, said once dialed in they are killer ECMs. Tune on it is on the rich side, could probably dial up boost and compensate just a bit
Greddy Boost controller with electronic vacuum block control, has all plugs and block.
Greddy Turbo Timer and Halmeter SF air/ fuel meter
Stock Brake booster, master cylinder, new clutch master, noname fuel pressure regulator and catch can
Stock pillowball mounts with upper spring cup
All this is in the midwest, my zip is 62040. You can call/text me at 618-709-2773 or reach me on here I usually check daily or so.
Shoot me offers, shipping is on the buyer, obviously bigger parts are preferred pick up.
Ill be updating this as I get more stuff off my shelves.
- Mr.Fujiwara
- Club4AG Expert
- Posts: 482
- Joined: Fri Jan 11, 2013 8:13 am
- Location: North Hollywood
Re: 20v GTS partout
.
Last edited by Mr.Fujiwara on Sun Oct 13, 2013 12:52 pm, edited 1 time in total.
Old username: Charskiezz
20V BT: Traded For F20c Swap
20V BT: Traded For F20c Swap
- Mr.Fujiwara
- Club4AG Expert
- Posts: 482
- Joined: Fri Jan 11, 2013 8:13 am
- Location: North Hollywood
Re: 20v GTS partout
Mr.Fujiwara wrote:Very Cool guy legit parts!!
buy his Stuff!! lol
GLWS Kiefer !!
Old username: Charskiezz
20V BT: Traded For F20c Swap
20V BT: Traded For F20c Swap
Re: 20v GTS partout
How much for the boost controller?
-
- Club4AG Enthusiast
- Posts: 64
- Joined: Sat Jul 13, 2013 4:54 am
Re: 20v GTS partout
very interested in both t50 trans and gts lsd rear end, how much is your best offer ?
Re: 20v GTS partout
Mrfuzzy- how's 60 sound?
Sent you a pm truenoguy86
Sent you a pm truenoguy86
-
- Club4AG Enthusiast
- Posts: 64
- Joined: Sat Jul 13, 2013 4:54 am
Re: 20v GTS partout
can you contact me via email please, apparently am new and cant use reply or compose a message yet :p
truenochild86 at gmail dot com
truenochild86 at gmail dot com
Re: 20v GTS partout
Monday bump!
Re: 20v GTS partout
How much for the zenki tails shipped to 92553 CA?
-John
-John
Re: 20v GTS partout
John h- wanna do 85$ shipped?
-
- Club4AG Regular
- Posts: 18
- Joined: Mon Jan 14, 2013 10:32 pm
Re: 20v GTS partout
Would you care to sell these two brackets in my picture that I circled? Please let me know. Thanks
Re: 20v GTS partout
boosted86 wrote:John h- wanna do 85$ shipped?
Shoot me an email johnholbach@ymailDOTcom
-John
-
- Posts: 3
- Joined: Tue Mar 26, 2013 12:24 pm
Re: 20v GTS partout
how much for both seat rails shipped to fremont ca?
- alavelle12
- Club4AG Enthusiast
- Posts: 90
- Joined: Sat Jan 19, 2013 2:41 pm
Re: 20v GTS partout
would you sell the lower alternator bracket?
Re: 20v GTS partout
Ill do 60 on the rails and then shipping so probably 80 shipped, lmk whatcha think
I don't really want to seperate any parts from the motor either ill sell it whole or put it bak together for my pickup
Getting ready to email you John h- did you mean at gmail.com?
I don't really want to seperate any parts from the motor either ill sell it whole or put it bak together for my pickup
Getting ready to email you John h- did you mean at gmail.com?
Re: 20v GTS partout
yo u still got the clutch/flywheel? u never texted me back, i'll still buy em from u if u have em.
And i know u said youd rather not part out the 20v but im still in for the water line setup if u decide to ^__^
And i know u said youd rather not part out the 20v but im still in for the water line setup if u decide to ^__^
Re: 20v GTS partout
boosted86 wrote:Ill do 60 on the rails and then shipping so probably 80 shipped, lmk whatcha think
I don't really want to seperate any parts from the motor either ill sell it whole or put it bak together for my pickup
Getting ready to email you John h- did you mean at gmail.com?
No, its ymail.com
Thanks
Re: 20v GTS partout
Do you still have the gts rear end and if you do how much for it and shipping to 22191 thank you
Re: 20v GTS partout
Very interested in your rear end, pm me. thanks
Re: 20v GTS partout
STILL HAVE THAT REAR END AVAILABLE?
-
- Posts: 8
- Joined: Tue Mar 12, 2013 1:53 am
Re: 20v GTS partout
howmuch for the motor?
Re: 20v GTS partout
where are you located? i'm interested in the transmission, rear end and heater core.
Re: 20v GTS partout
I'm out of Illinois near St. Louis. Rear end is gone already but I've got the trans an heater core/ blower assembly
-
- Club4AG Enthusiast
- Posts: 51
- Joined: Thu Jan 24, 2013 7:43 pm
- Location: SoCal
Re: 20v GTS partout
Still have seat brackets?
Re: 20v GTS partout
Yeah sure do
-
- Club4AG Enthusiast
- Posts: 51
- Joined: Thu Jan 24, 2013 7:43 pm
- Location: SoCal
Re: 20v GTS partout
boosted86 wrote:Yeah sure do
How much for the driver one?
Re: 20v GTS partout
where are you located
-
- Club4AG Regular
- Posts: 47
- Joined: Sat Apr 20, 2013 12:06 am
Re: 20v GTS partout
Is the diff still available!?!
Hmu if so
A sure buyer
Txt 5628963441
Names mike
Hmu if so
A sure buyer
Txt 5628963441
Names mike
Re: 20v GTS partout
Sorry rear end is gone
I'm out of Illinois right near St. Louis, Missouri
Pms and texts replied to
Brake booster gone
I'm out of Illinois right near St. Louis, Missouri
Pms and texts replied to
Brake booster gone