4AGZE on engine stand
4AGZE on engine stand
Might be a stupid question, but I want to put my 4AGZE on an engine stand. Do you use the transmission bolts?
Re: 4AGZE on engine stand
Depending on the type of stand, transmission bolts probably won't be long enough.
I had to buy some longer bolts and some heavy steel washers. Get the same thread
as the trans bolts... M12 x 1.25 (metric fine). I bought them 100mm long measured
from under the head, but 95mm would have been OK... needed to use quite a few
washers . That was to suit a standard China made stand... you will need to check
how long the bolts need to be for your stand.
Cheers... jondee86
I had to buy some longer bolts and some heavy steel washers. Get the same thread
as the trans bolts... M12 x 1.25 (metric fine). I bought them 100mm long measured
from under the head, but 95mm would have been OK... needed to use quite a few
washers . That was to suit a standard China made stand... you will need to check
how long the bolts need to be for your stand.
Cheers... jondee86
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
- gotzoom?
- Club4AG Expert
- Posts: 403
- Joined: Fri Jan 11, 2013 8:42 am
- Location: Silicon Valley, CA
- Contact:
Re: 4AGZE on engine stand
USDM bumper bolts work great. I shim with a stack of washers to fit my stand.
- oldeskewltoy
- Club4AG MASTER
- Posts: 2184
- Joined: Wed Jan 09, 2013 4:44 pm
- Location: Portland, Oregon
Re: 4AGZE on engine stand
If you have trailing arm bolts (the sizes that bolt to the axle) those are perfect length....
OST Cyl head porting, - viewtopic.php?f=22&t=300
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
Re: 4AGZE on engine stand
I had a set of spacers and bolts made for mine so I can put it on the stand with the flywheel on and still turn it.
Couldn't find the right things off the shelf.
Couldn't find the right things off the shelf.
-
- Club4AG Regular
- Posts: 29
- Joined: Thu May 14, 2015 10:31 am
Re: 4AGZE on engine stand
Cylinder head bolts work like a charm too. Maybe a few spaces and viola.