Hi all,

I bought the KOUKI [analog] JDM gauge cluster for my KOUKI USDM and I am trying to re-pin it as we speak.

I looked around the net and results are quite discouraging. I looked up here:

http://www.aeu86.org/viewtopic/ae86/t/4 ... c/start=75

http://www.aeu86.org/viewtopic/ae86/t/4 ... /start=100

But as you see, each one has their own different set of pinning, which I'm afraid doesn't even match with ours, as those are European 86s and checking line by line, we have at least 4 different colors thrown in our harness.

Since we lost all the past C4AG forum data (a minute of silence for all the lost knowledge) I am unable to find good reliable info for USDM harnesses.

I am trying to ask for anybody that has repinned his gauge cluster in hope that they did a "copy" of their "before and after" pining in some sort of graph, picture, etc that I could use.

Many thanks in advance for any leads or help!

I got something for you, I'll post up my friends stuff tomorrow. Proven to work, posted on the old board and used too.

Sweet! looking forward to that.

If you don't mind I have a few questions about it:

1. For the cables that need to be repinned from one plug to the other (the white and blue plugs for each side), did he have to extend them adding some wire, or what other thing did he do for them?

2. Is that info for the digi cluster or for the analog? zenki or kouki car? (not sure if the harness/colors of the cables change on koukis)

Thanks!