Was wondering if anyone happened to have that old thread archived about the fuel line/filter AN fittings, banjo & adapter sizes, it also had the aeroquip and earls part numbers for -6 line.
Sticky that bish if anyone finds it.

if you want to convert all your fuel lines to -an right from the tank, I recommend doing it the way I did. Parts cost was about $35 iirc.





Eliminateds the bottlenecks created when just putting -5 or -6 tube nuts on the hard lines that normally come off the pump hanger.

If you are just talking about making a -AN line from the filter to the rail, thats just a matter of using a 12mm banjo to male -6an adapter, a section of -an hose and a couple hose ends.

If you want the banjo adapter for the fuel filter, I have one that I would sell.