Hey CLub4ag,

So my JDM Kouki front bumper brackets and front turn signals came in today! While i am waiting on body work stuff to dry, i want to install it. After removing about 1,000,000 screws to get the USDM front bumper skins off, I am ready to put the new one on. However i don't know where exactly the JDM bumper brackets go?? does anyone have any pictures of the location? Sorry for the dumb post, I just don't know where they go haha.

Thanks everyone!

I think you should mount the brackets on the bumper first, then you should know how to do it, i did it with my zenki bumper

Honestly I would say do it how you think would be easiest you. I've done both, I prefer putting brackets on car then put the bumper on. Wouldn't hurt to have a friend to help

RLZ wrote:I think you should mount the brackets on the bumper first, then you should know how to do it, i did it with my zenki bumper

grappletech wrote:Honestly I would say do it how you think would be easiest you. I've done both, I prefer putting brackets on car then put the bumper on. Wouldn't hurt to have a friend to help

Thanks for your alls help! My bumper is still at the apartment so i haven't been able to try them on the bumper yet. To grappletech, does the actual USDM bumper beam need to come off or just the skin?

you are removing the whole USDM iron bar (and the brackets to the bar). then bolting in the JDM brackets, then the JDM "skin" to the brackets.

if you want proper bumper support, you're going to have to ditch the JDM brackets and snag one of these:
viewtopic.php?f=22&t=1602



or get one made yourself.

what Mikeyee said... I will eventually get a bash bar. Its all about protecting your investment!!!

Check this out while your at it.

viewtopic.php?f=22&t=1602

EDIT: Mikeyee im sorry i didnt see your link up there before

Mike, is that the bash bar that Alex makes?

nap, a piece the swangbiz guys make down south.

see here: viewtopic.php?f=22&t=1602