So on a whim I wrote the folks at Flaming River Industries about what would be need to get a Manual rack made for our 86s. They replied with the fallowing:
Inner end pivot points
Inner end thread
Front or rear steer
Will we be providing a mounting solution or just a rack that the customer will make mounts for
Long or short pinion
Amount of travel needed
If you get this info I can look into it. If we are doing mounts I will need at minimum an original rack to see where the mounts need to be on the rack and if it is feasible.
Tech Support Dept.
Flaming River Industries
First I would like to know if anyone is interested in the first place?
I would also like some help answering their questions I’ve had some difficulty tracking down any technical info. I know some of the old school pros on here will just know.
If interested, do you want them to come up with a mounting system? I personally think it would be more convenient even if it adds to the cost.
I have an old power steering rack I could send them as well as thing it mounts to(k-member?) if necessary.