Mostly for those that kept the stock manifold, what was your solution for the 2-1 section around the steering column?

I have an idea of what needs to happen, I'd just like to see what you guys did.

Most people chop the end and have custom piping routed around the shaft.

Yep, that's what I'm asking to see.

I will look a few up.

Reviving this thread to see if there have been any new updates. Are there header options now for this swap or is it still a modification that needs done?

Battle Garage will be coming out with a header for the beams 86 swap soon. They posted it on their facebook page.

aukword1 wrote:Battle Garage will be coming out with a header for the beams 86 swap soon. They posted it on their facebook page.

Awesome!! Btw, I’ve been following your swap progress! Looking good! I’m sure I’ll have some questions for you in the near future.

aukword1 wrote:Battle Garage will be coming out with a header for the beams 86 swap soon. They posted it on their facebook page.

I just scrolled around the battle garage fb and couldn't find anything about them making a header for the beams swap. That would make life a bit easier if they were.

Found it posted on Sept 18th. Hopefully this eventually happens cuz $1150 is cheap as far as these headers goes. My add a comment to get it back to the top.