I swapped in a ae92 smallport with a map, engine and dash harness. I have power to the igniter, coil, injectors but it will not start. Anyone have any ideas on where to start?

power to fuel pump?
Got fuel, spark, air?
Check timing is correct(dizzy is installed correctly)

The fuel pump is direct wired it works I have fuel to the fuel rail. And power to the injectors I dont have a noid light to see if they a getting ecu signal. Got power to the dist, igniter, and coil. I haven't pulled the plug to see if it sparks yet

The harness was missing the 12pin ecu plug. I got one and wired up the battery power and that's where im at crank but no start

if your getting spark & fuel

Check timing , make sure cams, crank and Dizzy
Are at TDC (top dead center),
There's chance it's just timing.