Wes picked me up a tranny mount from an auto sr5. Sacrificed it to make a template to bring to Joey at Performance Options.
****CENSORED****picture_of_my_terrible_welds.jpg****CENSORED****
Pulled my dash to fix my heater core. Before
Panky's in Hayward hooked it up. I brought it in and BS'd with them for a while and 5 minutes later it was done free of charge
After, reinforced now with new silicone hoses (not doing this ever again)
Installed and didn't have to remove the engine
Got around to drilling the hole for my bell housing. Bolted the bell housing to the plate, flipped it over, threw a 3/8" drill bit in the chuck.
Picked up my one piece. If anyone wants one PM me, I can get them done for any car (steel) for around $250 with your yokes/driveshaft pieces.
Took out camber from the front to look more flush
Rear pic just because
Delays at the machine shop. Parts wont be done until next week, then I have to tap them myself for the 3/8's bolt so they are easy to remove/service the pilot bearing. GAHHH I just want to drive...