As title says. Looking for what you may have available for a good exhaust manifold for a 16v 4ag. Prefer stainless but will entertain mild steel. Not looking for obx/trd/silkroad. Need something different.
Lets talk
Email me
pismir at yahoo dot com

Thank You

What kind of built engine you have?

Email sent

Orange Rocket wrote:What kind of built engine you have?

carillo rod
je piston
AE111 balance crank
304/288 cam
fcr 41
etc..

Danny90033 wrote:Email sent

Thanks for the email but no thanks, Looking for something different.

Where are you located and what is your budget?

There are few place that make super nice header in So- Cal for LHD AE86 those runs $1800 to $2200. depend on material you wan to use.

pchanichiban wrote:

Orange Rocket wrote:What kind of built engine you have?

carillo rod
je piston
AE111 balance crank
304/288 cam
fcr 41
etc..

Danny90033 wrote:Email sent

Thanks for the email but no thanks, Looking for something different.

I'll give this a bump but not counting on much.

Maybe I should just build one finally..

viewtopic.php?f=9&t=9448

I was originally looking at modeling one more off the Silk Road but I am trying to get a mockup chassis so I can make it a little more orginal and still clear everything. I would like to do a little high rise with some nice curves but that's as far as I have gotten.

where are you located?

I have one for sale.
if you are located Los Angeles area , i can have you test fit.

pchanichiban wrote:I'll give this a bump but not counting on much.

Maybe I should just build one finally..

I am in MN. Not going to work.

What one are you referring to that you have for sale?

Text me your number
310-254-680tree

pchanichiban wrote:I am in MN. Not going to work.

What one are you referring to that you have for sale?