*Testing waters* I want to go F20 so my driveline is up for sale. The car runs and drives, I just drove it to a drift event yesterday, drifted, and then drove home. Its a 3rib 4ag with side draft carbs. I have about 10k on this engine since I rebuilt it and put it in. I just got new jets for it and have been retuning it, the jets it came with were too rich. I have dyno sheets for the jets that came with the carbs, 113whp and 97tq.

$4k From engine to driveshaft. obo what do you got?

Mod list:
3 Rib 4ag stock bottom end with new piston rings and asin oil pump
rebuilt 16v bigport head
mild port and polish
HKS valve springs
Tomei poncams 264X8.15 IN+EX
HKS 1.6mm headgasket
ARP head studs
GReedy oil filter
Toyota timing belt.
48mm SK racing sidedraft carbs (with weber jets)
CF trumpets
cust throttle spacers
TRD sidedraft manifold
MSD 6al
MSD coil
OBX? 4-2-1 longtube headers
2"X12" test pipe
Trust DD exhaust
Hopes & Dreams




I'll post better Pics when I get home tonight

willing to part out the "hopes & dreams"?? bump for a sweet looking set up, tho! glws

I'm doing a similar build, question, how did those carbs flow with the poncams? and where is your power band?

Here is the dyno day I went to with the carbs running on the jets it came with. 160 main and 165 air/cor
AWD Mustang dyno. Third pull was 113.1bhp @ 7647rpm with 97.3tq @3007rpm

http://youtu.be/elV8FeL4fho

Friday bump? offers?

sunday funday price drop $3500. drop in and drive set up

did you see any gains wit the new jets? i have almost the identical setup, but with weber 45s and toda 272 cams. the dyno numbers look good, im hoping for 115whp