-Cup holder- $30
-ARP flywheel bolts (set)- $20
-Momo steering wheel- $100
-Personal (Nardi) Steering wheel- $100
-Ford EDIS coils x 4- $50
-Bluetop injectors- $50
-Injector resistor- $15
-Cold start injector-$5
-20 valve TPS pigtail- $5
-Water temp sensor- Sold
Pictures upon request:
-Shell with clean title- $500, includes doors, trunk lid, brake lines, glass, steering column, rear wire harness and remaining odds and ends. You will need a rear end, wheels and front suspension to make it a rolling chassis
-Rear wire harness- $150
-complete heater minus the climate control, includes all under dash venting- $100
-Driver and passenger door weather stripping, near perfect-$75
-Blue cloth rear seat- $100
-Blue kick panels, pair- $50
-Brake hard lines- $50 without proportioning valve
-Blue coupe trunk lid- $75
-Driver door, blue- $50 with glass and regulator, no locks
-Passenger door, blue- $75 with glass and regulator
-All glass available on car- Contact for price
-Window cowl- $25 Pick up only
-Front Side windshield moldings, not top-$20
-Brake shield, pair- $20
-Fuel door, blue with cable- $50
Aisin slave cylinder- $20
-Electric fan 14" (I don't remember the brand but its not a cheap ebay fan that will stop working in a week)-$20
-Blue top ECU- $30
-Crank pulley- Sold
-Power steering reservoir- Sold
-Charcoal canister- Sold
-Distributor heat shield- $10
-AC compressor bracket-Sold
-Spring insulators- Sold
-Heater valve- $10
-Starter plunger-Free with any purchase
-Engine brace- Free with any purchase
-FWD (I think) water pump housing- Free with any purchase
-Exhaust donut- Sold
-Earl's oil cooler- Sold
-1 lateral bar/panhard bushing (Energy)- $5
Air vent cup holder- Free with any purchase
-Fidanza lightweight flywheel (Probably needs new surface plate that can be purchased for $60)- Sold
-Act stage 3 pressure platen just buy a new disc and save money- $25
-Tranny crossmember- $25
All parts located in Redlands CA
Call or text Andrew (909)644-6420
