Hi guys,

I've got T50 rebuild kits available for sale. Also included are the bushings/washers for your shifter. $USD400 delivered to North America.

Note: There are 3 types of T50 gearboxes. Be sure that your input shaft bearing is the 68mm bearing (normally designated as Nachi 30RT06). Remove your gearbox clutch release bearing housing to get a look at the front input shaft bearing. If your gearbox was released on an AE86 from 1983 onwards, more than likely you will have the 68mm bearing.

Whats included in the kit:

1x Front - Input shaft bearing (Nachi Japan)
1x Rear - output shaft bearing (NSK Japan)
1x Centre - output shaft bearing (Koyo Japan)
1x Front - Countershaft bearing (Koyo Japan)
1x Centre - Countershaft bearing (Koyo Japan)
1x Rear - Countershaft bearing (Koyo Japan)
12x Needle roller bearings (Not pictured)

5x Synchros - Reverse has no synchro (Aftermarket)
2x Oil seals (Front input shaft & Rear output shaft - Toyota OEM)

1x Shifter bushing (Toyota OEM)
1x Shifter washer (Toyota OEM)
1x Shifter Ball rubber cup washer (Toyota OEM)

The paper gasket kit is omitted from this kit as they are prone to leaking. I've had better luck using Permatex or RTV silicone.
Heres a picture of the kit (Minus the needle rollers):



Lastly, if you need individual bearings/parts contact me. I will separate the bearings/synchros etc.

Send me a PM, or if you like you can send me an email: haxengineering@gmail.com

Cheers,

Will

location?

Gday there,

I'm based in Sydney, Australia.

$USD400 is what I'm going off as, or $430 Aussie dollars with the current exchange rate.

Cheers,

Will

very interested. email me at : klianochoa@gmail.com

Hi Guys,

Unfortunately I cannot respond to PM's just yet. I can be contacted directly via email: haxengineering@gmail.com

I'm currently upgrading these kits to include the obsolete caged needle bearings. To date no body has been able to supply the caged needle bearings for the past 7 years. I am having these custom made specifically for the T50 gearbox. I am only doing a small production run of these bearings. These are approximately 3 weeks away.

The estimated cost of these "ultimate" kits is $USD450 + shipping. These kits are being shipped from Sydney, Australia.

Cheers,

William

PM me if you have any left.

Bumping this for an Excellent seller.

b-rock wrote:Bumping this for an Excellent seller.

+1
I purchased a rebuild kit with a Mfactory 5th gear set(.737) from William last week.