hello guys!how are you?
This is the time for the starter to be relocated !
i want your "Lights" here cause the guide from ae92gts website is down...
i have bought the clutch "rear end plate" from ae92 latest 4afe that has the starter hole from the intake side....
Now i dont know the exact part number the mr2 turbo 1.4kw starter (that the ae92gts website proposed)
I found by myself from toyodiy mr2 turbo 3sge starter part number 28100-74070 but i am not sure that it is compatible with my project....
some help guys!


P.S.

My 20v ST header to my 16v engine project!
http://forums.club4ag.com/zerothread?id=111598
the header from the starter has a minimum distance even with the header spacer.

you can use an ae92 4afe or ae102 4/7afe starter.... same bolt pattern just a slightly lower output. I used a 4afe starter on smallport 4age's for years without issue.

I used the 4AGZE starter. Needed to mod my coolant lines a bit. Got it from local aftermarket auto parts place, Napa I think.

guys thank you for your fast answers.

The 4age 20v starter (which is a small one if i remember right) wont do the job?

Do we have some part numbers ?

p.s

You have used these starters relocated.Yes? to the intake side with an ae92 4afe rear end plate with the hole to the intake side?

hello guys... i have the trans out....and i am relocating the starter....the coolant pipe needs to be modified a bit...so i send it to a local machinery shop....

i am posting new photos from the starter relocation job and the 20v clutch flywheel installation !














Balanced








you can see the dots of balancing




the rear plate for the 4afe that i bought, as you can see has the starter hole from the intake side !