Does the Tomei Poncam requires a 2 step dowel pin?

no, and the info is on Tomeis site

http://www.tomei-p.co.jp/_2003web-catal ... m_4AG.html

I had posted the 16V dyno, and I realized after the fact you were asking about 20V

oldeskewltoy wrote::oops:


I had posted the 16V dyno, and I realized after the fact you were asking about 20V

No problem bro. Please give your valuable advice...

chemtrails wrote:no, and the info is on Tomeis site

http://www.tomei-p.co.jp/_2003web-catal ... m_4AG.html

I saw that and thanks for the guide. I was confused that whether a 2 Step Dowel Pin was required for Tomei Poncam setup? Therefore I don't need the dowel pin and that sounds great. One thing do I need to replace any other head internals with the poncam replacement?