Ok, I have bearings, pistons, rods, a stripped block and am ready to look at machine work. I need the block bored, and decked, crank polished for oversize bearings, and balanced as well as a 3 angle valve job for a small port head.
I searched the forum for recommended shops and everything I could find is old. Google doesn't have many shops pop up and while Bud's is highly reviewed I have seen where they had to farm out a 4a crank before because it was too small for them.
Machine shop olympia through kent
Machine shop olympia through kent
4age bigport in a 73 spitfire
- oldeskewltoy
- Club4AG MASTER
- Posts: 2184
- Joined: Wed Jan 09, 2013 4:44 pm
- Location: Portland, Oregon
Re: Machine shop olympia through kent
a fair bit south of you.... but still only a few hours.... Loynings is in Portland......
OST Cyl head porting, - viewtopic.php?f=22&t=300
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
Building a great engine takes knowing the end... before you begin
Enjoy Life... its the only one you get!
Re: Machine shop olympia through kent
I wish I had that kind of money. I asked around with some people I know and I think I will use Auburn Auto Machine. They were recommended by a few mechanics I know and they knew what they were talking about when I called them.
4age bigport in a 73 spitfire