blacktop FSM incorrect?
blacktop FSM incorrect?
Does anyone remember the correct timing setup for blacktop? I remember there was a thread on here on the old site.. we lost so many good threads..
Re: blacktop FSM incorrect?
Exhaust cam pulley knock pin placement
- HASport AE86
- Club4AG Expert
- Posts: 201
- Joined: Mon Jan 14, 2013 6:09 pm
- Location: Loma Linda, CA
Re: blacktop FSM incorrect?
You are to align the dowel pin on the exhaust cam WITH the pulley spoke that HAS A "5" and a "dot" on it. Following the FSM will in fact put your exhaust cam advanced 11 teeth and the distributor timing will be way off. At TDC #1, the dowel pin on the exhaust cam should be in about the 5 o'clock location and the slit for the distributor on the opposite side of the cam should be perfectly vertical at 12 o'clock.
SwangBiz Corolla Chassis Parts and F20/F22C/4AGE Wiring Services
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
(we build stuff, I solder wires, we race corollas, then we get drunk)
Proud Supporter of JSPfab.com, BattleGarage, and Solo8 LED Solutions
Re: blacktop FSM incorrect?
You can find that thread that HaSport and I did collectively...without knowing it.
viewtopic.php?f=4&t=1353
viewtopic.php?f=4&t=1353
haha cali...i got one of your 86's and you're not getting it back.
My turd of an 86
20v swapped 86 write-up
My turd of an 86
20v swapped 86 write-up