Page 1 of 1
1ZZFE COP Conversion
Posted: Mon Mar 20, 2017 11:55 am
by SlidewayzAE86
Just wondering if I could get more details on this setup...
I'm running megasquirt 2 3.57 on AE92 4AGZE...
Was curious if anyone had experience with this setup...
And also wondering if anyone has a set for sale..
Re: 1ZZFE COP Conversion
Posted: Mon Mar 20, 2017 4:09 pm
by aukword1
I am doing this conversion in the very near future. I ordered the blanking plate from SQ-Engineering. They also have some very helpful articles on their website. Basically they have four pins, one pin goes to ground, one pin to ignition on power source and another to the ECU. One pin is for some sort of sensor that is not needed. You have to setup the megasquirt to send the signal to the coilpacks. I have the PNP version so its a lot easier for me but I am sure it can't be too hard. Megasquirt 2 and 3 are both compatible with doing this conversion.
Re: 1ZZFE COP Conversion
Posted: Tue Mar 21, 2017 9:34 pm
by SlidewayzAE86
Awesome ok thanks...I got the 1ZZFE coils yesterday and I'm gonna install them Thursday....I'll keep you updated and let you know
Re: 1ZZFE COP Conversion
Posted: Thu Mar 23, 2017 8:30 am
by aukword1
Re: 1ZZFE COP Conversion
Posted: Thu Mar 23, 2017 8:45 am
by SlidewayzAE86
Ok thank you...I appreciate the help
Re: 1ZZFE COP Conversion
Posted: Thu Mar 23, 2017 1:57 pm
by SlidewayzAE86
Boom...started right up first time lol...runs better actually. Still running rich though but I'm gonna start tuning it to get better. No plug wires and no coils cleans up the bay alot too lol
Re: 1ZZFE COP Conversion
Posted: Fri Mar 24, 2017 7:28 am
by aukword1
very nice man, congratz on the new mod
Re: 1ZZFE COP Conversion
Posted: Fri Mar 24, 2017 7:40 am
by SlidewayzAE86
It was so much easier than I thought too...since the megasquirt had 2 spark outputs, just wired 1and4 to spark A and 2and3 to Spark B....NO ecu setting change at all. Now it's time to clean up the wiring and get the plate done for the coils
thx again for the support and advice....I do appreciate it
Re: 1ZZFE COP Conversion
Posted: Fri Mar 24, 2017 8:06 am
by aukword1
No Problem, can't wait to do it myself. Just waiting on the blanking plate for the distributor, have everything else already. Glad everything worked out easy for you.