sent pm

jayson

not a "sunk in valve job", As Rogue pointed out the chamber wall where the ridge was... isn't by the bottom view. That ridge in the chamber wall gets very hot, and will cause ping/pre-ignition. minimize that sharp edge, and the chamber can withstand considerably more compression. Ridge, or...

ive seen one before years ago I forget who had it.Niki? autoplus??..for fiberglass those sure where built good thought...better than most of the stuff going around though,had latches and reinforced good with bolt holes for hood hinges

got money to burn?!?!? its a good buy$$

jayson

got a clutch with a engine trans deal and this is what I got.its very usable and in good condition he said it was toda ...its not a toda but it is a trd pressure plate and a act clutch and some kinda flywheel...make me an offer $$ or trade...$50 and piece of bubblegum isn't going to get you a clutch...

sent a request..

jayson

this is what you need to do to the cylinder head chambers to safely run higher compression http://i79.photobucket.com/albums/j143/oldeskewltoy/MOmo/3chanber3panel.jpg Im not sure what im looking at but..is that sunk in valve job or something? jayson not a "sunk in valve job", As Rogue poi...

oldeskewltoy wrote:this is what you need to do to the cylinder head chambers to safely run higher compression

Im not sure what im looking at but..is that sunk in valve job or something?

jayson

gotzoom? wrote:Max doesn't have a set of smallport pistons laying around?

he said I should buy new ones , but I have a baby on the way and dont have $$$$

jayson

what happened to make you give up so easily? It would be cheaper to throw in some OEM high comp pistons in the blacktop block, than rebuilding the bluetop bottom end. or you could roll it like me... Using a stock unmolested big port head, stock head gasket, you should be fine on the blacktop block,...

thank you all your info was a big help .. I think I might have gotten into something I am not ready for...I was looking for a cheap build with street engine and was thinking cheap A, because I had the block and pistons and rod bearings that are good. B, because my blue top bottom took a spin and nee...

noone has done this!?!!?

we are using stock 20v pistons and a trd headgasket ... will this work??

jayson

your clutch rocks!!!

jayson

I have put this engine together and it seems to have really small clearance. the engine spins but I was wondering will the valves hit and bend?


Jayson

sold another one thank you Nestor

jayson

man clean truck...good luck with the sale..

if this was in cali you would sell it in a min

jayson

16v

got them for $70 shipped in the USA 4age 16v .8mm 81.5mm bore http://img.photobucket.com/albums/v720/krashdog/2012-11-19120600.jpg http://img.photobucket.com/albums/v720/krashdog/2012-11-19120600.jpg my paypal krashdog36@yahoo.com or text 510-303-6330 names Jayson