Are there any “low profile” wheel bearing dust caps?
Are there any “low profile” wheel bearing dust caps?
I’m trying to fit some center caps on the front wheels but the dust caps protrude a lot so not sure if there is an alternative. Let me know!
Re: Are there any “low profile” wheel bearing dust caps?
If you're going to cover them you could consider flatening the dust cap with a hammer. Not sure how far you can get with that, most axles protrude far enough that the cap doesn't leave much room under the cap. Pull a cap and check your axle length to see where you can go with it.
One shot, one kill.
Re: Are there any “low profile” wheel bearing dust caps?
If you only need a few millimetres more to allow you to fit your low profile centre caps,
you could maybe get there with some slip-on wheel spacers. You may need to get some
longer wheel studs if you go that route.
Cheers... jondee86
you could maybe get there with some slip-on wheel spacers. You may need to get some
longer wheel studs if you go that route.
Cheers... jondee86
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.