GTS Gearbox Plate?

User avatar
Kitsunami
Club4AG Enthusiast
Posts: 100
Joined: Thu May 05, 2016 11:36 am

GTS Gearbox Plate?

Postby Kitsunami » Tue Mar 21, 2017 1:19 pm

Hey all,

Anyone know if I can use my AW11 MR2 Tranny / Block Plate for my GTS swap? I believe the MR2 plate is cutoff about 3/4 the way down compared to the AE86 GTS plate... but I don't know for sure.

I know this is a GTS plate:
Image

I'm going to venture a guess that I *could* use it, but that I should custom-fab the remaining portion to prevent things from getting into my bellhousing?

Any suggestions are appreciated. I don't see these plates for sale much, and they're certainly not addressed in FWD / RWD 4AGE engine conversion logs I've seen. If I can McGuyver something that'll do the job, I'd prefer to go that route rather than trying to source one.

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.


aukword1
Club4AG Expert
Posts: 432
Joined: Fri Dec 06, 2013 6:03 pm

Re: GTS Gearbox Plate?

Postby aukword1 » Tue Mar 21, 2017 2:11 pm

I tried doing something similar with a 4agze plate. I believe the starter holes didn't match up or was on the opposite side. I don't see why you wouldn't be able to make it work with a little modification if it even needs it. Worst case scenario you can probably fab one out of sheet metal.

User avatar
mad_86
Club4AG Expert
Posts: 352
Joined: Fri Jan 25, 2013 3:40 pm
Location: Socal

Re: GTS Gearbox Plate?

Postby mad_86 » Wed Apr 12, 2017 3:15 pm

i think i have a spare GTS plate LMK if your intrested

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.



Return to “TECH: Corolla AE86”

Who is online

Users browsing this forum: No registered users and 4 guests