Partout (AE86/Cressida) Updated 2/9/17

GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Partout (AE86/Cressida) Updated 2/9/17

Postby GreenLantern » Sun Jan 22, 2017 11:30 am

https://sfbay.craigslist.org/eby/pts/5996689904.html

Suspension parts below are for X7 Cressida but will fit other Toyotas too: Celica, other Cressidas, Supra, etc.

PAIR (2) Work meister S1 15x9 -15 4x114 - SOLD
PAIR (2) Falken Azenis 205/50/15 BRAND NEWSOLD
PAIR (2) Appliance Mesh 14x7 unknown offset $150 SOLD
BC Coilovers for mx73 Cressida (no rear shocks) - $450 SOLD
T3 NRCA for mx73 Cressida - $100
T3 angle knuckles for mx73 Cressida - $100 SOLD
mx63 LONG lca for mx73 Cressida w/ newish balljoints (These are 365mm long, 65mm longer than AE86 lca, and about 50mm longer than stock mx73 lca - $75 SOLD

AE86 T3 quad caliper bracket - w/ one pair S13 calipers $275 SOLD
AE86 gt-s front seats (black and very clean) $350 SOLD
AE86 JDM steering wheel (very clean) $200 SOLD
AE86 Air Conditioning Complete SOLD
AE86 P/S pump/lines etc. (Make offer)
AE86 SR5 drum rear end complete (Make offer)


1JZ-GTE non-vvti ECU (may have bad capacitors) $40
1JZ-GTE igniter $50 each
326 power wing SOLD
PBM hydro with Wilwood dual caliper reservoir $120
Custom Stainless steel lines for hydro (run from hydro back to brakes with T) $50 (cost me $180)
Autometer 5" tachometer $50


In search of:
AE86: Aftermarket Sway Bars, Manual rack

Image20170209_185746 by roushman90, on Flickr
Image20170209_185150 by roushman90, on Flickr
Image20170209_185139 by roushman90, on Flickr
Image20170209_185128 by roushman90, on Flickr
Image20170209_185113 by roushman90, on Flickr
Image20170209_185104 by roushman90, on Flickr
Image20170209_184522 by roushman90, on Flickr
Image20170209_184502 (1) by roushman90, on Flickr
Image20170209_184442 by roushman90, on Flickr
Image20170209_184424 by roushman90, on Flickr
Image20170209_184348 by roushman90, on Flickr
Last edited by GreenLantern on Tue Mar 21, 2017 9:08 am, edited 9 times in total.

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.


GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Re: 1JZ Corona partout (Some ae86/cressida/etc)

Postby GreenLantern » Tue Jan 31, 2017 4:09 pm

Bump, pbm hydro dual caliper and stainless lines still available along with 326 power wing, Autometer 5" tachometer

GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Re: 1JZ Corona partout (Some ae86/cressida/etc)

Postby GreenLantern » Mon Feb 06, 2017 8:00 am

Bump, need this stuff gone to fund new build! =)

sterae86
Club4AG Regular
Posts: 12
Joined: Thu Mar 21, 2013 4:33 pm

Re: Cressida & Ae86 partout (Some ae86/cressida/etc)

Postby sterae86 » Mon Feb 06, 2017 10:54 pm

Want to part with the supra axle shafts ?

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.


GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Re: Cressida & Ae86 partout (Some ae86/cressida/etc)

Postby GreenLantern » Wed Feb 08, 2017 12:59 pm

sterae86 wrote:Want to part with the supra axle shafts ?


Rear end is pending trade, mainly interested in swapping for a 6.7" gt-s complete housing w/ LSD which would be about equal in value to my rebuilt condition 7.5".

If the trade falls through, and no one else is willing to swap for it, then I will sell the entire thing outright.

GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Re: Partout (AE86/Cressida) Updated 2/9/17

Postby GreenLantern » Fri Feb 10, 2017 8:36 am

Photos of gt-s seats and jdm wheel added, see bottom of original post for stuff I will trade for!

4agshoob
Club4AG Expert
Posts: 227
Joined: Fri May 03, 2013 8:18 pm
Location: ATL, GA

Re: Partout (AE86/Cressida) Updated 2/9/17

Postby 4agshoob » Mon Mar 13, 2017 6:07 pm

Intereated in custom hydro rear brake line.
Image

GreenLantern
Club4AG Enthusiast
Posts: 57
Joined: Wed Jan 09, 2013 8:55 pm

Re: Partout (AE86/Cressida) Updated 2/9/17

Postby GreenLantern » Tue Mar 14, 2017 12:55 pm

4agshoob wrote:Intereated in custom hydro rear brake line.


Text me at 510-566-5296. I can send some photos. Will make a deaaal for the lines WITH the PBM hydro assembly!

Disable adblock

This site is supported by ads and donations.
If you see this text you are blocking our ads.
Please consider a Donation to support the site.



Return to “AE86 Parts & Accessories”

Who is online

Users browsing this forum: Baidu [Spider], Google Adsense [Bot] and 6 guests