Perhaps we should break this down into bite size chunks ?
1.
First the clutch. I gather you bought a clutch kit which included a new clutch
plate, pressure plate and throwout bearing. You changed all of these, put the
tranny back in the car, connected everything up, and now the clutch...
(A) Works as normal, or
(B) Does not work at all ?
2.
Second, the exploded bearing in your transmission. Was this...
(A) The spigot bearing in the center of the flywheel, or
(B) The throwout bearing which pushes against the pressure plate, or
(C) The gearbox input shaft bearing on the front of the gearbox, or
(D) Something else ?
3.
Third, the motor not putting out power. Does this mean...
(A) The motor starts and runs but when you engage the clutch to start the car
moving, the car does not move, or
(B) The motor starts and runs and when you let the clutch out the car tries to
move but it has no power and stalls, or
(C) The motor starts and runs, and when you let the clutch out the car starts
to move as normal, but when you try to accelerate, the motor bogs down and dies, or
(D) Something else ?
More information is always better when asking for advice. And you will have more
chance of getting good advice if you provide an accurate description of the problem
Cheers... jondee86