Anyone know what brand this is? I know it's not factory as it's missing the 02 sensor bung.
I'm trying to figure out all the gaskets I'll need, after re-installing the header.
I seem to be missing 17300, VALVE; and 1719A, Gasket.
I just had the two gaskets after the VALVE: Gasket 17173, and 17177.
Do I need the first two? (17300, 1719A) Any ideas why it would be missing?
Thanks,
ian
Exhaust header type?
-
- Club4AG Pro
- Posts: 644
- Joined: Thu Oct 06, 2016 2:23 pm
- Location: Middle of Hell, Florida
Exhaust header type?
Success guardian... Successsssssss..
Re: Exhaust header type?
According to this thread... http://www.club4ag.com/forums/viewtopic ... 205#p68162
... that is a TRD header (like the one on the left side of the pic).
The 17300 valve is the TVIS plate. The 17179A 8-hole gasket goes in front
of the plate and the 17177 4-hole gasket goes behind the plate. I guess if you
are using the TVIS plate you will need both gaskets. 17173 is the exhaust
manifold gasket, and you definitely will need that
Cheers... jondee86
... that is a TRD header (like the one on the left side of the pic).
The 17300 valve is the TVIS plate. The 17179A 8-hole gasket goes in front
of the plate and the 17177 4-hole gasket goes behind the plate. I guess if you
are using the TVIS plate you will need both gaskets. 17173 is the exhaust
manifold gasket, and you definitely will need that
Cheers... jondee86
The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable man.
-
- Club4AG Pro
- Posts: 644
- Joined: Thu Oct 06, 2016 2:23 pm
- Location: Middle of Hell, Florida
Re: Exhaust header type?
Thanks Johndee! Perfect answer as always!
Success guardian... Successsssssss..
Re: Exhaust header type?
easy way to tell if TRD or OBX copy look at the EGR hole
TRD= Is straight up, egr lines up, perfect fitment
OBX= is at an Angle and won't line up, must bend egr pipe to fit
thats what i look for first, then the Collector TRD is a nice even collector, deep V
obx not so clean Short V collector
TRD= Is straight up, egr lines up, perfect fitment
OBX= is at an Angle and won't line up, must bend egr pipe to fit
thats what i look for first, then the Collector TRD is a nice even collector, deep V
obx not so clean Short V collector