Just wondering if I could get more details on this setup...
I'm running megasquirt 2 3.57 on AE92 4AGZE...
Was curious if anyone had experience with this setup...
And also wondering if anyone has a set for sale..
1ZZFE COP Conversion
Re: 1ZZFE COP Conversion
I am doing this conversion in the very near future. I ordered the blanking plate from SQ-Engineering. They also have some very helpful articles on their website. Basically they have four pins, one pin goes to ground, one pin to ignition on power source and another to the ECU. One pin is for some sort of sensor that is not needed. You have to setup the megasquirt to send the signal to the coilpacks. I have the PNP version so its a lot easier for me but I am sure it can't be too hard. Megasquirt 2 and 3 are both compatible with doing this conversion.
-
- Club4AG Regular
- Posts: 48
- Joined: Wed Feb 12, 2014 12:00 pm
Re: 1ZZFE COP Conversion
Awesome ok thanks...I got the 1ZZFE coils yesterday and I'm gonna install them Thursday....I'll keep you updated and let you know
Re: 1ZZFE COP Conversion
Awesome, good luck to you. Here are some articles that I found to be useful for the swap..
http://www.86garage.com/forums/viewtopic.php?p=10869
http://www.sq-engineering.com/tech-arti ... info-guide
http://www.msextra.com/forums/viewtopic ... 16&start=0
Just in case you get stuck.
http://www.86garage.com/forums/viewtopic.php?p=10869
http://www.sq-engineering.com/tech-arti ... info-guide
http://www.msextra.com/forums/viewtopic ... 16&start=0
Just in case you get stuck.
-
- Club4AG Regular
- Posts: 48
- Joined: Wed Feb 12, 2014 12:00 pm
Re: 1ZZFE COP Conversion
Ok thank you...I appreciate the help
-
- Club4AG Regular
- Posts: 48
- Joined: Wed Feb 12, 2014 12:00 pm
Re: 1ZZFE COP Conversion
Boom...started right up first time lol...runs better actually. Still running rich though but I'm gonna start tuning it to get better. No plug wires and no coils cleans up the bay alot too lol
Re: 1ZZFE COP Conversion
very nice man, congratz on the new mod
-
- Club4AG Regular
- Posts: 48
- Joined: Wed Feb 12, 2014 12:00 pm
Re: 1ZZFE COP Conversion
It was so much easier than I thought too...since the megasquirt had 2 spark outputs, just wired 1and4 to spark A and 2and3 to Spark B....NO ecu setting change at all. Now it's time to clean up the wiring and get the plate done for the coils thx again for the support and advice....I do appreciate it
Re: 1ZZFE COP Conversion
No Problem, can't wait to do it myself. Just waiting on the blanking plate for the distributor, have everything else already. Glad everything worked out easy for you.